515db819ab
The 12 board-level rows now live at the end of the 遥信量 page instead of a separate 开入开出 page: 8 opto inputs (DI_A..DI_H) and 4 relay outputs (KO6/TRIP/ERT/CLZ). 33 rows become 45, five pages become six. The standalone page, its menu entry, its golden references and both build registrations are removed. Folding the display is not folding the point table. The board rows render from dio_di_* / dio_do_* and stay out of yx_bits / yx_valid / yx_dp: any change to those carriers is provably absent from this diff. IEC 104 mapping and YX_VALID_MASK are untouched, so nothing new is reported to a master station. Input polarity was wrong and is fixed here. On this board a 24 V input drives the opto, which pulls the 74HC165 pin LOW, so the raw mask is inverted relative to "has signal". The bit assembly only reordered bits; nothing converted the level. The screen showed 分 on every channel no matter what the operator drove in. Polarity now converts once, in the driver, behind IOBOARD_DI_LEVEL_ACTIVE (0 = active low), so callers see 1 = has signal for both inputs and outputs. Verified on the board: page 5 shows YX33 followed immediately by DI_A, crossing the 33-point boundary with no drift; DI_C reads 合 because the operator's signal is on channel C, the other seven read 分; page 6 shows DI_H then all four outputs 释放. Page rows end at y=134, the footer starts at y=144. Input bit order is only partly verified: channel C was confirmed against a real signal, the other seven have not been exercised channel by channel. The board detects the presence of 24 V, not contact closure, and the output rows show the shadow register (our intent) rather than mechanical contact feedback. All three limits are recorded in the page header and in the IOBOARD README. Also adds a polarity guard to the host tests: the input polarity was flipped once already, and until now no assertion would have caught a silent re-flip, since only the DO side was pinned.